Installation:

Prep your toilet:

Remove your existing toilet seat, then turn off the shutoff valve and drain the tank by flushing the toilet. Disconnect the water supply hose from the toilet tank.

Tip: You may need a wrench to disconnect the water supply hose. Use a container or towel to catch any excess water.

Install your T-valve:

Connect your T-valve to the toilet tank fill valve, then reconnect the water supply hose to the bottom of the T-valve and connect the straight end of the bidet hose to the open side of the T-valve.

Tip: Use a bit of Teflon tape to create a watertight seal, and hand-tighten to avoid stripping the connection threads.

Install your mounting plate:

Use the adjustable brackets to place the mounting plate in the best position for your toilet bowl, then insert and tighten the plastic bolts to securely fasten your mounting plate to the toilet bowl.

Attach your Omigo:

Slide your Omigo onto the mounting plate until it “clicks” into place and connect the 90° elbow end of the bidet hose to your Omigo.

Tip: If the seat appears too short or too long for the toilet, adjust the mounting plate brackets by loosening the bolts and sliding the seat forward or backward.

Final checks and steps:

Check connections are properly secured, turn on the shutoff valve while checking for leaks, then plug in the power cord. Use the cable clips to connect the power cord and bidet hose side-by-side for a tidier appearance.